"I hired Wimberley Contractors to remove and replace my old nasty rockwool insulation with spray foam. They also spray foamed the insulation in my wall for a remodel. Once hired they wasted no time getting the work started and completed. Worked late and on weekends as needed. Hard to find contractors no days that still honor and respect the need to customer service, however Wimberley Contractors met and exceeded my expectations. Quality of work was also well done. I’m no expert on spray foam however my Sheetrock guys stated they did “really well”. I will hire again if the need arises in the future. Highly recommend!!"
Open-Cell · Closed-Cell · Metal Buildings
Spray Foam Insulation in San Angelo, TX
Spray foam insulates and seals in one pass. We spray houses, remodels, metal shops, and barndominiums across the Concho Valley, and the quote is free.
Insulation and Air Seal in One
Spray Foam Insulation for West Texas Homes and Shops
Open-cell where it makes sense, closed-cell where it's needed, and a straight answer about which one your building calls for.
Spray foam goes on as a liquid and expands to fill every gap it touches, so it insulates and stops air leaks at the same time. That matters in San Angelo, where summer sun bakes roofs and metal siding for months and the wind pushes dust through any crack it can find. Foam sticks tight to wood and steel and does not settle.
We spray open-cell and closed-cell foam on roof decks, in open walls during remodels, and on metal buildings, shops, and barndominiums. If old insulation is in the way, we take it out first — one customer had us pull out old rockwool and replace it with foam. Not sure foam fits the budget? Blown-in attic insulation usually costs less, and we will quote both.
- Open-cell spray foam
- Closed-cell spray foam
- Metal building insulation
- Shop and barndominium foam
- Roof-deck attic foam
- Wall foam for remodels
- Old rockwool and batt removal
- New-build wall and roof foam
Sweating Steel and Hot Ductwork
Problems Spray Foam Insulation Solves Around San Angelo
Foam costs more than blown-in, so it should go where it does the most good. These are the places.
-
Metal Shop Too Hot for Summer Work
Bare steel soaks up sun and radiates it inside; foam on the panels cuts that heat down.
-
Condensation Dripping from the Metal Roof
Warm, damp air hits cold steel and drips; closed-cell foam keeps that air away from the metal.
-
Ductwork Sitting in a 130-Degree Attic
Foam on the roof deck brings the attic and your ducts inside the insulated space.
-
Dust and Drafts Coming Through the Walls
Foam fills the cracks around plates, wiring, and pipes that batts leave open to the wind.
-
Old Rockwool or Batts That Have Fallen Apart
We remove worn-out insulation and haul it away before any new foam is sprayed.
From Masking to Trimmed Foam
How a Spray Foam Insulation Job Works
Four steps, and you know the price before we spray anything.
-
Walk the Building Together
We look at the walls, roof, or metal panels and ask how you use the space.
-
Pick Open-Cell or Closed-Cell
We explain which foam fits each area and give you a free quote.
-
Clear Out, Mask, and Spray
Old insulation comes out, windows and floors get covered, and the foam goes on.
-
Trim Foam Flush with the Studs
Wall foam gets shaved even so drywall hangs flat, and we clean up before leaving.
Foam for Concho Valley Buildings
Where Spray Foam Fits in San Angelo's Climate
Sun on steel, dust in the wind, and a long cooling season shape how we use foam here.
Foam for Metal Shops and Barndominiums
Steel buildings outside town heat up fast; foam sprayed right on the panels slows that down.
Sweating Metal Roofs
Big day-to-night temperature swings make bare metal roofs sweat; closed-cell foam keeps damp air away.
Roof-Deck Foam over Attic Ducts
Most local homes run ductwork through the attic; roof-deck foam keeps that space far cooler.
Hail, Wind, and Closed-Cell Foam
Closed-cell foam cures hard and adds some stiffness to metal panels and wall framing.
Blowing Dust and Leaky Walls
Foam seals the small cracks where blowing dust works its way into houses and shops.
Open Walls in Older Ranch Homes
When a remodel opens the walls of an older ranch home, that is the time to foam them.
From Foam and Insulation Customers
Reviews from Our Spray Foam and Insulation Customers
"Ryan was very professional, listened to what we had in mind for insulation, and worked with us on a very reasonable price. Him and his team got the job done in less than 2 full days. Very trustworthy- I would use him again."
"Amazing new insulation installed at our house. I would highly recommend Wimberley!"
Spray Foam Questions
Spray Foam Insulation FAQs for Homes and Metal Buildings
What is the difference between open-cell and closed-cell spray foam?
Open-cell foam is soft and light, expands a lot, and does a good job filling wall cavities and dampening sound. Closed-cell foam is dense and rigid, packs more R-value into each inch, and resists water. We usually suggest closed-cell on metal and talk through both for houses.
Will spray foam stop my metal building from sweating?
In most cases, yes. Metal sweats when warm, damp air touches cold steel. Closed-cell foam sprayed directly on the panels keeps that air from reaching the metal, so water has no cold surface to form on. It also cuts the heat that radiates off the steel in summer.
What does it mean to spray foam the roof deck instead of the attic floor?
The foam goes on the underside of the roof instead of on top of the ceiling. That brings the whole attic, and any ductwork in it, inside the insulated part of the house. The attic stays much closer to indoor temperature, so your ducts no longer sit in 130-degree air.
Can you spray foam the walls of a house that is already finished?
Spray foam needs open stud bays, so wall foam is done during a remodel, an addition, or a new build, before the drywall goes up. If your walls are closed and staying that way, the roof deck is usually where foam does the most good.
Do you have to remove old insulation before spraying foam?
Where the foam is going, yes. Foam needs to bond to clean wood or metal, so old batts or rockwool in those cavities come out first. On roof-deck jobs we usually recommend clearing the old insulation off the attic floor too. We handle the removal and haul it away.
After the Foam Cures
Other Work We Do Alongside Spray Foam Insulation
Free Spray Foam Quotes
Need Spray Foam on a San Angelo Home or Shop?
Tell Ryan what you're building or fixing, and we'll come look at it and price it for free.
Houses, Shops, and Barndominiums
Request a Spray Foam Insulation Quote
Send the building size, whether it's wood or metal, and which areas you want foamed. We'll follow up with a time to come look.
Hours of Operation
- Monday 7:00 AM – 7:00 PM
- Tuesday 7:00 AM – 7:00 PM
- Wednesday 7:00 AM – 7:00 PM
- Thursday 7:00 AM – 7:00 PM
- Friday 7:00 AM – 7:00 PM
- Saturday 7:00 AM – 5:00 PM
- Sunday Closed
Request a Free Quote
Tell us what you need — we'll reach out quickly with pricing and availability.